Logo

P2437 Engine Trouble Code

Meaning of P2437 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P2437 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for P2437 code is occuring now you should check P2437 repair processes.
Now don't ask yourself; What should you do with P2437 code ?
The solution is here :

P2437 Possible Solution:

P2437 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

P2437 Code Meaning :

P 2 4 3 7
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) O2 Sensor Heater Circuit Malfunction Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector) Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P2437 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P2437 engine trouble code is about Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical.

Main reason For P2437 Code

The reason of P2437 OBD-II Engine Trouble Code is O2 Sensor Heater Circuit Malfunction.

P2437 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.